F1 25 (2026 Season Pack) UDP Telemetry Setup for Xbox Series X|S
You can stream real-time telemetry from EA SPORTS F1 25 with the 2026 Season Pack on Xbox Series X|S to PitStatus running on a Windows PC on the same local network. This setup gives Xbox drivers access to corner-by-corner delta comparisons, tyre wear projections, and ERS energy analysis during practice, qualifying, and race sessions.
The instructions below explain how to configure your Xbox, verify that telemetry is arriving on your PC, and solve common home network issues.
Step-by-step Xbox Series X|S setup
- Find your PC local IP address: Open PitStatus on your Windows PC and open the Game Setup panel (or Connection panel) to read your primary local IP address (such as
192.168.1.105). - Check your home network setup: Make sure your Xbox Series X|S and your Windows PC are connected to the same home router, avoiding guest Wi-Fi networks that isolate connected devices.
- Open the telemetry settings on Xbox: Launch EA SPORTS F1 25 with the 2026 Season Pack on your Xbox, enter the main menu, and select Options > Settings > Telemetry UDP (or Game Settings > UDP Telemetry).
- Turn on UDP Telemetry: Change the UDP Telemetry option to On so the game begins sending telemetry data.
- Choose your transmission method:
- Direct IP (recommended): Set UDP Broadcast Mode to Off, and enter the local IP address of your Windows PC into the IP Address field. This direct route provides the most consistent delivery across Wi-Fi.
- Broadcast mode (alternative): Set UDP Broadcast Mode to On (the game ignores the IP Address field). This method requires no manual IP entry, provided your local router permits subnet broadcast traffic.
- Set the UDP port: Enter
20777as the UDP Port to match the default listening socket in PitStatus. - Configure rate and format: Set UDP Send Rate to 60 Hz, and ensure UDP Format is set to
2026. - Enable public telemetry: Set Your Telemetry to Public and Show Online ID to On to record data from rival drivers in multiplayer sessions.
- Exit the pit lane: Start a session and drive out of the garage onto the track so the console begins transmitting live telemetry.
Check that data is arriving
You can verify that PitStatus is receiving data from your Xbox through these visual checks:
- In the app header and inside the Game Setup panel, the connection status changes from a pulsing grey indicator to a solid green dot labelled "F1 Connected · Data arriving".
- The connection confirms active reception, alongside the active circuit name and session type.
- While paused in menus or parked in the pit garage, F1 25 (2026 Season Pack) transmits only intermittent data; live telemetry activates the moment the car takes to the track.
Common problems
- Xbox and PC on separate network subnets or guest Wi-Fi: If your Xbox is connected to a guest Wi-Fi network and your PC is on the primary network, the router isolates them. Ensure both systems share the same home Wi-Fi or wired Ethernet network.
- Active VPN client running on the Windows PC: If a VPN is active on your Windows PC, it may redirect network traffic or block local subnet UDP broadcasts. Pause your VPN or configure it to allow local subnet bypass while running PitStatus.
- Router blocking UDP broadcast data: If you selected broadcast mode on Xbox but PitStatus shows no incoming data, your wireless router may discard broadcast traffic between Wi-Fi and wired devices. Switch UDP Broadcast Mode to Off in F1 25 (2026 Season Pack) on Xbox and enter your PC direct local IP address instead.
- Windows Firewall blocking incoming console data: The Windows Firewall on the receiving computer might block UDP data originating from other devices on the network. Open the Connection panel in PitStatus and click "Repair Windows Firewall" to confirm that UDP port 20777 is open for the local subnet.
- Telemetry menu options greyed out in F1 25 (2026 Season Pack): If you cannot change telemetry values in the Xbox game menu, go to the general gameplay settings and switch the driving style to "Expert". Casual assistance presets can lock telemetry configuration fields.